|
|
|
|
 |
CLOCKLAB ADDITIONAL 56-CHANNEL INTERFACE (448 MAXIMUM CHANNELS)
|
Contact our Behavioral Research Specialists for more information
|
|
|

ClockLab's 56-channel interface is a small (8" wide) box that connects to the computer via a USB cable. Using a USB hub, up to 8 interface boxes can be connected to a single computer, for 448 input channels.
Each interface box has on its face 8 RJ-45, or ethernet-style, connectors. These connectors have 8 pins. As shown in the diagram below, one pin serves as a ground, and the other as inputs for 7 different channels. Each switch (or other input device, such as an infrared motion detector) is simply connected between the ground and one of the signal pins. When the switch closes, the program detects an event on the corresponding input channel.
Each input channel can be used to count events on a switch or other detector. Or it can be configured to detect the lights in the experimental room or chamber. For light detection, a photodetector (provided) is connected to the input channel, and the program is configured to store that channel's data as the light cycle for a specified set of counting channels.
Also availalbe are simple breakout boxes that convert each RJ-45 input to 7 pairs of banana jacks for direct connection to switches and light detectors.
|
|
 |
|
|
|
|
 |
7-CHANNEL BREAKOUT BOX FOR CLOCKLAB
|
Contact our Behavioral Research Specialists for more information
|
|
|

Used to convert each RJ-45 input to 7 pairs of banana jacks for direct connection to switches and light detectors.
|
|
 |
|
|
|
|
 |
4-CHANNEL STIMULUS LIGHT EXPANSION
|
Contact our Behavioral Research Specialists for more information
|
|
|

Converts one of the two RJ-45 rear panel low voltage outputs on the ACT-556 or -556A into four separate and controllable BNC outputs.
|
|
 |
|
|
|
|
 |
4-CHANNEL STIMULUS BREAKOUT BOX
|
Contact our Behavioral Research Specialists for more information
|
|
|

Converts one of the two RJ-45 rear panel low voltage outputs on the ACT-556 or -556A into four separate and controllable 28VDC AUX connections used by Coulbourn modules.
|
|
 |
|
|
|
|
 |
CLOCKLAB SOFTWARE FOR CIRCADIAN BIOLOGY
|
Contact our Behavioral Research Specialists for more information
|
|
|

Data Analysis and Collection for Circadian Biology
Does it take you longer than 30 seconds to measure phase shifts? If so, ClockLab, the industry standard for the collection and analysis of circadian activity data, can help. It combines a point-and-click interface with state-of-the-art algorithms. Embedded controls turn each graph into a powerful interactive tool for data analysis. Our users enjoy ClockLab's speed and convenience. ClockLab's Analysis program has been applied to mice, hamsters, rats, drosophila, humans, bees, algae, Eurasion Lynx in the zoo, radio-tagged squirrels in the wilds of Alaska, horseshoe crabs, and soil chemistry signals from the Mars Viking Lander.
ClockLab's data collection program incorporates a large array of features at reasonable cost: Up to 448 channels on a desktop or laptop machine USB interface for instant setup Integrated light control and light recording High-density switch connections Remote data access via internet Record switches, motion detectors, Minimitter ER-4000's Paste actograms and other plots into presentation graphics programs like PowerPoint, Illustrator or Photoshop. Every graph is completely editable. Automated detection of activity onsets and offsets makes it possible to Measure phase shifts Measure mean alpha Predict future activity onsets... all with a few mouse clicks. Zoomable actograms for easy navigation through long records. Just drag on an interesting part of the actogram to zoom in. Then click to display the periodogram, FFT or activity profile for the chosen data segment. Chi-squared periodograms, activity profiles, FFT's and auto-correlograms. Bout anlaysis. Export all data and analyses to spreadsheet files. Access data in many formats, including...ClockLab format, Stanford Software's Chronobiology Kit, Actiwatch, Dataquest, Minimitter, Trikinetics and others. Extensive batch processing capabilities for printing and analysis. Windows compatible.
Analysis program (Circadian Toolbox)
A single-computer license for the analysis program can be purchased on its own. It requires the purchase of Matlab (The Mathworks, Natick, MA). Only the basic Matlab is required. Toolboxes, simulink, the compilers and Excel Builder are not required. The Student verison is not recommended and will not work for large data files.
Complete system (Data collection and analysis)
56 Channels 1 56-channel interface box 112 Channels 2 56-channel interface box 168 Channels 3 56-channel interface box 224 Channels 4 56-channel interface boxes Light-control hardware 8 channels per interface. Up to 100 additional channels available with special purpose output hardware Minimitter E-Mitter recording module. Hardware available separately from Mini-Mitter. Ordered as add-on to 56 or more channel-system. Preconfigured computer Preloaded software, data acquisition boards and drivers (Monitor not included). Complete system setup We will help identify and install chambers, cages, wheels and other sensors.
Multi-computer site license for the ClockLab Analysis program is available with each data collection system.
Upgrades of the data collection and analysis program are free for 3 years.
System Requirements
The data analysis system runs on Windows 2000/XP and requires only the basic MATLAB program (no toolboxes or Simulink necessary) from The MathWorks, Inc. if your institution does not already have a site license available.
Data collection requires a computer running Windows 2000/XP with a clock speed of 500 MHz or greater and 128 MB memory. Monitor resolution of 1024x768 or better. Zip drive , flash memory stick or network connection recommended for accessing files during data collection.
|
|
 |
|
|
|
|
 |
LIGHT SENSOR
|
Contact our Behavioral Research Specialists for more information
|
|
|

The ACT-554 will detect the presence of light. Use in ClockLab systems where the light cycle is being controlled to provide a record that the lights were on and off as programmed.
|
|
 |
|
|
|
|
 |
CLOCKLAB 56-CHANNEL INTERFACE AND SOFTWARE - INCLUDES ONE ACT-556A
|
Contact our Behavioral Research Specialists for more information
|
|
|

ClockLab's 56-channel interface is a small (8" wide) box that connects to the computer via a USB cable. Using a USB hub, up to 8 interface boxes can be connected to a single computer, for 448 input channels.
Each interface box has on its face 8 RJ-45, or ethernet-style, connectors. These connectors have 8 pins. As shown in the diagram below, one pin serves as a ground, and the other as inputs for 7 different channels. Each switch (or other input device, such as an infrared motion detector) is simply connected between the ground and one of the signal pins. When the switch closes, the program detects an event on the corresponding input channel.
Each input channel can be used to count events on a switch or other detector. Or it can be configured to detect the lights in the experimental room or chamber. For light detection, a photodetector (provided) is connected to the input channel, and the program is configured to store that channel's data as the light cycle for a specified set of counting channels.
Also availalbe are simple breakout boxes that convert each RJ-45 input to 7 pairs of banana jacks for direct connection to switches and light detectors.
|
|
 |
|
|
|
|
 |
MOUSE CAGE WITH RUNNING WHEEL - MS
|
Contact our Behavioral Research Specialists for more information
|
|
|

The ACT-551-MS-SS activity wheel mouse cage design was developed in a leading circadian rhythms lab and has been found to be extremely reliable, easy to clean and inexpensive.
The wheel is made of stainless steel material and the rotation counting uses a silent magnetic switch.
The switch has two banana plugs at the upper left and lower right corners of black switch housing. These are not electrically connected, but plug into the red banana jacks in the cage wall to hold the switch in place. The switch is therefore easily removable for cage cleaning.
Other mouse models and options are available under request (ask us for more information):
- ACT-551-FIL-MS-SS: Mouse Cage with Stainless Steel Running Activity Wheel - Magnetic Switch - Filter Lid
- ACT-551A-MS-SS: Small Mouse Cage with Stainless Steel Running Activity Wheel - Magnetic Switch
- ACT-551A-FIL-MS-SS: Small Mouse Cage with Stainless Steel Running Activity Wheel - Magnetic Switch - Filter Lid
- ACT-551SS: Mouse Cage with Stainless Steel Running Activity Wheel - Reed Switch
- ACT-551-FIL-SS: Mouse Cage with Stainless Steel Running Activity Wheel - Reed Switch - Filter Lid
- ACT-551A-SS: Small Mouse Cage with Stainless Steel Running Activity Wheel - Reed Switch
- ACT-551A-FIL-SS: Small Mouse Cage with Stainless Steel Running Activity Wheel - Reed Switch - Filter Lid
The Coulbourn activity wheels are no longer provided with nickel-coated steel wheels. Contact us for more information about the Stainless Steel replacement options.
ACT-551 Wheel Dimensions: 8.4" x 14.25" x 5.6" H
|
|
 |